2905TV SILVER SERVICE® curtain machine. 1/2 H.P.

No. 2905-TV curtain motor combines versatility with the power and drum capacity needed to operate large draw curtains. Draw curtain machine with electronic frequency control. The most versatile of the ADC line, these machines provide all of the features of an intermediate draw machine plus user definable variable speed control, acceleration ramps, deceleration ramps, overload protection, low voltage control, emergency stop loops and a host of other features. In addition these machines allow the use of inverter duty 3-phase motors on single phase power sources. Machines are equipped with integral limit switches for deceleration and emergency over-travel, programmable frequency drive units, low-voltage control, and can be operated from any number of remote control stations (except speed adjustment is so equipped). If versatility is a project requirement, the "TV" series of machines are the best option. A Cable Tension Device is included as standard equipment.
Output drums are 8" diameter x 12" long and are grooved for 3/16" wire center cable. Maximum cable travel is 90'. Cable speed is 0 to 72 fpm.

SKU: 2905TV SILVER SERVICE® curtain machine. 1/2 H.P.
2905TV SILVER SERVICE® curtain machine. 1/2 H.P.

ROTARY LIMIT SWITCH
Allows for user defined decelerated pre-set stops for the "Full
Open" and "Full Close" positions. The limit assembly is also
supplied with emergency overtravel limit switches which bypass
the deceleration ramps and shut the machine off immediately.
DISCONNECT SWITCH
Toggle switch which removes power to machine’s internal
circuitry.
FREQUENCY CONTROL DRIVE
Provides user definable parameters of operation. Examples are:
run speed, maximum obtainable speed, minimum obtainable
speed, acceleration ramp time and deceleration ramp time.


List Price: $9,383.47
Price: $7,506.78 each
You save: $1,876.69 (20%)

Installing a 2905TV drum curtain motor? Click here to watch installation video.

Horsepower: 1/2
Volts: 120/220 (1 phase) or 208/230 (3 phases)
Phase: 1 or 3
Cable speed: 0-72 fpm (variable)
Maximum one way cable travel: 90 feet.
Number of wires for remote control: 4
Control voltage: 24 VAC
Approximate dimensions: 42"L x 30"W x 18"H
Approximate shipping weight: 230 lbs

CABLE TENSION DEVICE
Automatically helps eliminate cable slack. Also helps retain cable within grooves of drum.

EMERGENCY HAND CRANK
Facilitates hand operation of curtain in case of mechanical or power failure.

GROOVED CABLE DRUM
Assures positive drive without cable slippage. Aluminum construction
8" diameter x 12" long. Coated wire-center cable must
be used. Drum must be at least 14' from track live end pulley, or
last pulley in system to allow cable to wind properly on drum.

VARIABLE SPEED (0-72 RPM) Speed cannot be adjusted while machine is operating without effecting limit positions.

NOTE: Guard (ME-1) not shown. Required for ETL compliance.

Draw curtain machines and drapery motors cannot be used for lifting, since they are not designed for an overhung type of load.


Back
We welcome designers, decorators, production companies, window covering and school equipment companies among other suppliers!!

Credit Cards Welcome
We welcome designers, decorators, production companies, window covering and school equipment companies among other suppliers!!
LAUSD Safety Prequalified
LAUSD Safety Prequalified
California Certified Small Business
California Certified
Small Business